General
When a go-around is required, perform the procedure in the stated sequence. Push the takeoff/go-around (TO/GA) switch, select flaps 15 and verify a positive climb before the associated gear and mode control panel (MCP) checks. After flap retraction, select level change (LVL CHG) as stated. Maintain the assigned flight-control response and follow the assigned missed-approach route, speeds and altitude. This procedure is not a general failure checklist. For a subsequent approach, create a new phase record and verify the current configuration. Do not reuse completion evidence from the discontinued approach.1. TO/GA — Push
When the stated condition is satisfied, push the assigned TO/GA switch once. Verify the resulting thrust and flight-mode indications.Checks and evidence
Checks and evidence
Expected response: PushVerification: Require the intended takeoff/go-around mode outcome for the configured aircraft.
2. Flaps lever — 15
When the stated condition is satisfied, select 15. Verify the required lever detent and actual flap/slat configuration.Checks and evidence
Checks and evidence
Expected response: 15Verification: Verify the chosen lever detent and the required actual flap/slat configuration.
3. At positive climb: Landing gear lever — Up
Condition: At positive climb. When the stated condition is satisfied, select the landing gear lever UP. Verify the required lever position and gear indications.Checks and evidence
Checks and evidence
When: At positive climb.Expected response: UpVerification: For DOWN, verify the required safe indications; for UP/OFF, require actual lever and gear-state evidence appropriate to that command.
4. At positive climb: MCP missed approach altitude — Verify
Condition: At positive climb. Verify the assigned missed-approach altitude on the MCP at the stated condition. Verify the selected target independently of actual altitude.Checks and evidence
Checks and evidence
When: At positive climb.Expected response: VerifyVerification: Read back the selected missed-approach target in feet.
5. At positive climb: Flap lever — As directed
Condition: At positive climb. When the stated condition is satisfied, select the directed flap detent. Verify the required lever detent and actual flap/slat configuration.Checks and evidence
Checks and evidence
When: At positive climb.Expected response: As directedVerification: Verify the chosen lever detent and the required actual flap/slat configuration.
6. After flap retraction: Pitch mode — LVL CHG
Condition: After flap retraction. After the required flap retraction, select LVL CHG and verify the active pitch mode and approved targets.Checks and evidence
Checks and evidence
When: After flap retraction.Expected response: LVL CHGVerification: Require actual LVL CHG engagement and the intended targets.