Go-around and missed approach
When a go-around is required, perform the procedure in the stated sequence. Push the takeoff/go-around (TO/GA) switch, select flaps 15 and verify a positive climb before the associated gear and mode control panel (MCP) checks. After flap retraction, select level change (LVL CHG) as stated. Maintain the assigned flight-control response and follow the assigned missed-approach route, speeds and altitude. This procedure is not a general failure checklist. For a subsequent approach, create a new phase record and verify the current configuration. Do not reuse completion evidence from the discontinued approach.1
TO/GA — Push
When the stated condition is satisfied, push the assigned TO/GA switch once. Verify the resulting thrust and flight-mode indications.
2
Flaps lever — 15
When the stated condition is satisfied, select 15. Verify the required lever detent and actual flap/slat configuration.
3
At positive climb: Landing gear lever — Up
Condition: At positive climb.When the stated condition is satisfied, select the landing gear lever UP. Verify the required lever position and gear indications.
4
At positive climb: MCP missed approach altitude — Verify
Condition: At positive climb.Verify the assigned missed-approach altitude on the MCP at the stated condition. Verify the selected target independently of actual altitude.
5
At positive climb: Flap lever — As directed
Condition: At positive climb.When the stated condition is satisfied, select the directed flap detent. Verify the required lever detent and actual flap/slat configuration.
6
After flap retraction: Pitch mode — LVL CHG
Condition: After flap retraction.After the required flap retraction, select LVL CHG and verify the active pitch mode and approved targets.