After landing
Begin after the landing/rollout condition and assigned after-landing point are verified. Do not retract flaps or disarm braking because a final-approach checklist has finished. Apply the off and up selections below. Verify weather-radar operating mode separately from its overlay on the navigation display (ND). Use the assigned route and taxi procedure for movement to the parking position.1
Autobrake — OFF
Select autobrake OFF. Verify the selector and required indications.
2
Speedbrake lever — Down
Set the speedbrake lever to DOWN. Use the applicable lever-detent conversion and verify the required position.
3
Probe heat — OFF
Select probe heat off for all applicable probe heat systems on the configured aircraft.
4
Exterior lights — As needed
Set the exterior lights for the assigned taxi operation. Verify each requested light; this checklist does not specify a complete lighting-panel setup.
5
Engine start switches — OFF
Select both engine start switches OFF. Verify both rotary-switch positions. These switches are separate from the fuel/start levers.
6
Weather radar — OFF
Select weather radar off and verify its operating mode. Hiding the weather overlay on the navigation display does not establish that the radar is off.
7
Flap lever — Up
When the stated condition is satisfied, select UP. Verify the required lever detent and actual flap/slat configuration.
8
Transponder — As needed
Set code and mode from the mission/clearance, then verify both. Code and mode are separate requirements.