General
Complete the preliminary, CDU, captain and first-officer procedures in the applicable ground configuration. Retain the side-specific requirements. A captain instrument or control does not satisfy an independent first-officer or standby check. Use the assigned detailed panel procedures for Set, Check, Test and Pass requirements. Observe the specified result and restore the required operating configuration after each actual cockpit test. Do not operate a system merely because its control appears in the reference list. Complete loading, performance preparation and the required equipment checks before progressing to the dependent departure procedures. Where an item requires an external inspection or crew adjustment, retain the assigned verification or explicit scenario exclusion.1. Initial data — Set
Enter the required CDU initial data. Confirm the page and field before entry, then verify the accepted value.Checks and evidence
Checks and evidence
Expected response: SetVerification: Verify the actual target field on the expected page and the accepted value.
2. Navigation data — Set
Enter the assigned route, runway and navigation procedure. Review the route and any modification before EXEC.Checks and evidence
Checks and evidence
Expected response: SetVerification: Read back the intended route and relevant procedure/leg information on its displayed pages.
3. Performance data — Set
Enter the performance data for the actual aircraft loading and configuration. Verify the accepted weights, flap, trim and reference-speed data.Checks and evidence
Checks and evidence
Expected response: SetVerification: Verify accepted data and performance outputs for the actual aircraft loading.